water-in-oil - PET INSTRUMENTS - PRODUCTS - Anshan Electrostatic Technology Research and Design Institute Co., Ltd

PRODUCTS

PET INSTRUMENTS

water-in-oil

【YSH series water-in-oil detector】
　　These serial instruments can continuously on-line display the changes of water content rate in oil transport pipe on line.The primary meters are divided into insert-form TYPE A and pipe TYPE B. TYPE A can be used to monitor and detect water-in-oil rate in large-diameter pipeline, and can be freely on-line installed and removed at low pressure. TYPE B can be directly installed in the diameter of below 3 in.(three sizes: 1-in, 2-in and 3-in). For large diameter pipeline, TYPE B can be installed in by-pass pipeline. In case of not completely mixing between oil and water and more oil impurities, it is recommend that TYPE B pipeline detector should be chosen.

◎　Main Characteristics:
　　Good detecting output linearity and high detecting precision.
　　On line real-time, liquid crystal display and direct observation.
　　Over a range of 0-100% water content rate, detection may be performed separately as requested.
　　Adopting standard signal output and being easily linked with computer.
　　Small size, less weight, low power consumption , reliability and safety.

◎　Technical parameters
　　Monitoring range:0-10%，0-20%，0-40%，0-60%，0-100%.
　　Monitoring precision:±0.3%，±0.6%，±1.2%，±1.8%，±3%.
　　Output mode:a.4-20mADC(or 1-5VDC ).
　　Output mode:b.relay contact output.
　　Output mode:c.liquid crystal display on the clock dial.
　　Power supply:220VAC/50Hz or 24VDC.
　　Medium temperature: +35-+150℃.
　　Work pressure: ≤2.5Mpa( special requset can be meet ≤4MPa).
　　Explosive grade:EX(ia) ⅡAT3.

微信图片_20251020095437.jpg